Dynacord PM 502 - testni izdelek

935.18€

1,161.71€

Ta inovativni izdelek prihaja v zelo sodobni, moderni obliki, in je najnovejša generacija mešalnih miz z ojačevalcem, v družini Dynacord. PM 502 je vsestranska naprava, zelo priporočljiva za manjše skupine, lokale, manjše butike, hotelske bare in tud..

  • Brez DDV: 935.18€
  • Blagovna znamka: Dynacord
  • Šifra: MES001
  • Razpoložljivost: Dobavljivo 2-3 dni

Ta inovativni izdelek prihaja v zelo sodobni, moderni obliki, in je najnovejša generacija mešalnih miz z ojačevalcem, v družini Dynacord. PM 502 je vsestranska naprava, zelo priporočljiva za manjše skupine, lokale, manjše butike, hotelske bare in tudi cerkve. Izpolnjuje vse akustične zmogljivosti, ki se jih pričakuje od kakovostnih izdelkov družine Dynacord.

Spletna stran proizvajalca: Dynacord PM 502

Channels (mono + stereo)
5 + 3
Microphone inputs
5 x XLR/Jack socket
Auxiliaries (FX, AUX)
1 Post, 1 Pre
Rated output power, 20-20000 Hz, THD < 0.5%, one channel loaded
-
into 4 Ω
640 W
into 8 Ω
350 W
Max. dual channel output power, dynamic headroom, IHF-A
-
into 4 Ω
2 x 600 W
into 8 Ω
2 x 340 W
Max. single channel output power, continuous, 1 kHz, THD = 1%
-
into 4 Ω
500 W
into 8 Ω
280 W
Max. midband output power, 1 kHz, THD = 1%, dual channel
-
into 4 Ω
2 x 450 W
into 8 Ω
2 x 270 W
Rated output power, 20-20000 Hz, THD < 0.5%, one channel loaded
-
into 4 Ω
2 x 400 W
into 8 Ω
2 x 240 W
Max. output power, Direct Drive mode (bridge configuration), continuous, 1 kHz, THD = 1%
-
into 12 Ω
680 W
Maximum output voltage, power amplifier, 1 kHz, no load
-
Dual channel mode
52 Vrms
Direct Drive mode
100 Vrms
THD, at 1 kHz, MBW = 22 kHz
-
MIC input to master A L/R outputs, +10 dBu, typical
< 0.015%
MIC iput to speaker output
< 0.15%
DIM 30, MIC input to speaker output, 3.15 kHz, 15 kHz
< 0.05%
IMD-SMPTE, MIC input to speaker outputs, 60 Hz, 7 kHz
< 0.15%
Frequency response, -3 dB, ref. 1 kHz
-
Any input to any Mixer output
15–22000 Hz
Any input to Speaker output
20–22000 Hz
Microphone mute switch attenuation
-
Amplifier Ch1/Ch2
< -85 dB
Channel to channel
< -78 dB
Microphone mute switch attenuation
> 100 dB
Channel VOL and FX/AUX send attenuation
> 85 dB
CMRR, MIC input, 1 kHz
> 80 dB
Input sensitivity, all level controls in max. position
-
MIC
-65 dBu (435 μV)
LINE (mono)
-45 dBu (4.35 mV)
LINE (stereo)
-27 dBu (34.6 mV)
CD (stereo)
-27 dBu (34.6 mV)
All other outputs (impedance balanced)
-
MIC inputs, GAIN at min. position
+11 dBu
Mono line inputs, GAIN at min. position
+30 dBu
Stereo line inputs
+26 dBu
PHONES output
+21 dBu
MASTER A, B, AUX outputs
+11 dBu
Input impedances
-
MIC
2 kΩ
CD
10 kΩ
All other inputs
> 15 kΩ
Output impedances
-
PHONES
47 Ω
All other outputs (impedance balanced)
150 Ω
MASTER VOLUME down
-129 dBu
Noise, channel inputs to MASTER A L/R outputs, MBW = 22 kHz, Aweighted
-
MASTER VOLUME down
-99 dBu
MASTER VOLUME center, all channel volume down
-90 dBu
MASTER VOLUME center, all channel volume center
-85 dBu
Signal-to-noise ratio, power amplifier, A-weighted, 450 W, 4 Ω
104 dB
Output stage topology, amplifier
Class D
Equalization
-
Low shelving filter
±15 dB / 60 Hz
Mid peak filter
±12 dB / 2.4 kHz
High shelving filter
±15 dB / 12 kHz
Master EQ 7-band (63, 160, 400, 1k, 2.5k, 6k, 12k Hz)
±10 dB / Q = 1.5
Filter
-
Low-cut filter, microphone processing (switchable)
80 Hz, 18 dB/oct. or 150 Hz, 12 dB/oct.
Low-cut filter, amplifier (engaged in Direct Drive mode)
50 Hz or 70 Hz, 18 dB/oct.
Speaker processing
LPN, switchable
Delay MASTER B, selectable
0–145 ms (0–50 m)
Effects
-
Type
Stereo 24/48-bit multi effects processor
Effect presets
32 factory presets, user editable
Remote control
Footswitch
Display
128 x 64 pixels, LCD
Audio player (USB at front panel)
-
Switching mode power supply (μC controlled)
FAT 32